WPM #10

Waterproof sealant for joints and fasteners

ASTEC WPM #10 waterproofing is a fluid applied acrylic formula, with high solids and fiber which dries to a tough, yet flexible and monolithic membrane that does not permit the passage of water. Applied as specified, WPM #10 is intended for use on roofs and walls – especially over seams, fasteners, joints, flashings, intrusions, and repairs. This product is intended as a base coat to be covered with an ASTEC finish coating for extended protection from ultraviolet and environmental degradation. WPM #10 may be combined with ASTEC #101 Accelerator to enhance cure time. (see ASTEC #101 Accelerator product sheet for instructions)

  • Seams
  • Fasteners
  • Joints
  • Flashings
  • Intrusions and repairs

MAINTENANCE

If used on a roof, check it every 6 months for structural damage and remove accumulated debris. Check ceramic finish coat annually for surface integrity. Repair any cuts, cracks or punctures according to General Requirements of Application Specification.

HEALTH AND SAFETY

Product is non-toxic and non-flammable. See this product’s Material Safety Data Sheet for further information.

QUICK FACTS

Color Light blue
Weight/litre: 6,12 kg
Solids content In volume: 65%
In weight: 69%
Dry film thickness 1000 microns per layer
Coverage rate 0,6 m² /l
Permeance 27.8
Prime Pigments Titanium
Solvent type Water
Drying times
To touch 1-2 hours at 24 °С
Full dry 48 hours
Full cure 21 days

Apply is by brush or industrial roller. ASTEC WPM #10 is NEVER reduced in water. Apply directly out of container. Recommended rates of coverage and dry film thickness vary by substrate and purpose. Usual specifications call for a two coat application over seams, flashings, and repair areas to a combined thickness of 1000 micron or 0,6 m² /l.